The KiCAD 6 project for the Bosch 005 ECU used in the Mercedes-Benz 350SL and 450SL with simulation is now […]
Because all four signals have a known, fixed relationship to each other, we just need to know when one of […]
Following on from my previous post starting this idea, next is how to send the pulses to the ECU. The […]
Here is an idea for electronic version of the pulse generator. The pulse generator uses blocks that wear down with […]
In order to finalize the ECU tester board design I needed to know how much current the ECU requires. I […]
In this topic I will describe how the D-Jetronic basic fuel injector pulses are created with the aid of circuit […]
I previously wrote about how to simulate an MPS in KiCAD. Here is how to tweak the model to match […]
This is version 2 which allows the vacuum to be varied over time during the simulation. The circuit simulator – […]
I recently started to suspect that I had made a mistake with this simulation, getting the timing of the outputs relative […]
The TPS takes the position of the throttle linkage and generates four outputs: When the throttle is 2% or less […]
