I modified the design so that it has usable handles even if the wires are routed to the side to […]
I have finally worked out the magic formula to 3D print a female ECU connector using cheap and easily obtainable […]
This post documents the development of version 1 of the ECU tester. This has since been replaced with version 2. […]
This is for measuring out of the car although my picture shows it installed in the car. The “rotor” has […]
The adjustment screw on the Manifold Pressure Sensor (MPS) came from the factory with a plastic protective cap, intended to […]
I recently started to suspect that I had made a mistake with this simulation, getting the timing of the outputs relative […]
