The KiCAD 6 project for the Bosch 005 ECU used in the Mercedes-Benz 350SL and 450SL with simulation is now […]
I modified the design so that it has usable handles even if the wires are routed to the side to […]
I have finally worked out the magic formula to 3D print a female ECU connector using cheap and easily obtainable […]
Here are the details of the male connector found on the engine wiring harness.
A demonstration of the overrun condition during deceleration where fuel injection is temporarily disabled. This is another way to view […]
In this video I use the ECU tester to demonstrate what the start signal is for and how it affects […]
The following video demonstrates the idle overrun – what it does and how it works. See the videos section at […]
